Search results for query: *

Hey everyone... thanks for all of your help and suggestions. it was great finding this forum and throwing out a question ...... Problem was resolved.... faulty BFT ... well thats the way it goes..cheers everyone until my next post...toodlepip

once again thanks guys !!!!! ..... all your help has been great .... the last bunch of posts have answered the "why no screen?" scenario. FYI .. Browsing through the hard drive I found reference to 3.7, therefore a 3.x system ... and yes the HDD did have NT4.0 on it. thanks for that tip. So it...

thanks a lot guys for your input. Went onsite this morning .. took out the HDD and accessed it ok via external drive bay. Copied data to make sure OK.. All seems ok. Put HDD back into BCM cage, but used external power for the drive... same BCM400 scenario, flashing leds and no HDD led on. So if...

thanks for your comments guys .. but one thing nags me .. the keyboard/mouse/monitor connections on the BFT don't need drivers loaded on the harddrive (pls correct if I am wrong) so when all bits connected up I should at least get something from that array, especially on boot up ??? or am I...

Many thanks for the guidance, I have reposted in the suggested section.... cheers

I have a BCM400 that survived a power cut and restoral, and now has the MSC/WAN/MODEM/NIC1/NIC2 leds flashing continuously. The HDD led is off and the status led is flashing. The caps on the base board are blue..so the green thoery is out. I have no access to system via NIC1 or 2, no access via...

I have a BCM400 that survived a power cut and restoral, and now has the MSC/WAN/MODEM/NIC1/NIC2 leds flashing continuously. The HDD led is off and the status led is flashing. The caps on the base board are blue..so the green thoery is out. I have no access to system via NIC1 or 2, no access via...