Search results for query: *

Thanks for your replies. "ditty -a ttya13" shows all settings the same. I agree that it seems the problem is flow control related, but haven't a clue about where to check other than ditty. Any suggestions?

Thanks for your quick responses! I forgot to mention that the peripheral is not configured as a printer port. It was set up as a terminal in the MPI port configuration in both the pre and post configuration disks so it isn't using the interface, model or printer files (as far as I know).

We are limping along on a system that runs an application under SCO 3.2v4.2. It has a Digi C/CON 16 attached. We ran into several problems that we thought would be solved by reinstalling the software for the concentrator via Digi's MPI software. Having very limited knowledge of UNIX, we ended...

We have an old application that is running under SCO UNIX r3.2v4.21 on an old ALR Optima 5133 PC. The hardware is dying. Our plan is to replace the application and hardware but until we do, we want to have a backup for the existing hardware. Does anyone know where I can get another ALR Optima...

It seems that my best bet is to find another PC with a SCO Unix compatible disk drive. Thanks to all.

This PC uses SurePath BIOS that doesn't seem to have a way to change the settings.

I'm a Unix lightweight, so the following is over my head: "in 3.2.4.2 IDE setting is set to normal not LBA" Could you please explain?

Thanks. I've got the release notes and installation guide documentation. I'll try the different bootstrings, although there's nothing there specifically for the disk being used (Quantum Fireball 1280MB AT).

I am trying to load (fresh install) SCO Unix r3.2v4.21 on an old Pentium-based IBM PC with a 1.2GB ide disk. After I select "Fully Configurable Initialization", the system just sits there. I've also tried the "Automatic Initialization", but the same thing happens. All the...