Search results for query: *

Seve, Thanks - That was exactly what I needed. I'm just not familar with bay commands yet. Worked perfectly (factory default) as well as the default passwords. MANY THANKS to ALL!

Well, to be honest. I'm not sure. I'm pressing 'any key to stop autoboot' to enter monitor> mode then entering the commands specified. (see output in previous post) Is this what you mean? --------------------- Press any key to stop autoboot monitor> config sys set flags factorydefault true...

I've tried both the rwa/rwa and the secret/secret username/password combinations as well as the 'boot' instead of 'reset'. Maybe it isn't saving correctly?? The output is listed below as everyone can see. Accelar Monitor v2.0.1 CPU: 60Mhz PPC 403GCX Type 2 Rev 1 in Slot 5 DRAM: 32M...

More info: Am I doing something wrong to get this password reset?? -------------------------------------------------- Accelar Monitor v1.3.5 CPU: 60Mhz PPC 403GCX Type 2 Rev 1 in Slot 4 DRAM: 32M Chassis: 1200 Reason for Last Reset: WDT Slot 1 is occupied Slot 2 is occupied Slot 3 is...

I tried the method listed...however after I enter: Type: config sys set flags factorydefault true Type: save config Type: reset Login: rwa Password: *** I get this: [12/22/2003 00:53:36] WARNING Code=0x1ff0009 Task=tShell Blocked unauthorized c li access Login: [12/22/2003 00:53:40]...

Purchased a Accelar from eBay to setup a home network for training. I've read stories on here about some difficulties on resetting some of Bay's other hardware - does the same hold true with the Accelar? I'm needing to reset this to factory defaults....any ideas? Thanks in advance!