Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations Rhinorhino on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. satman5152

    PBX - Cisco voice card

    kcbell: Change Feature access code to 8 for AAR, cha dial plan to 8 is a feature. (fac) then 8 will point to your AAR. I assume u r not using 8 for anything else. I hv a 3660, and i do Tie lines also on T-1, over satellite, for your DS1 setup are u sending all 00000000 as the idle code to the...
  2. satman5152

    PBX - Cisco voice card

    Are u using VOIP on the Cisco, which IOS is on the 3640? What is the Tru type; Tie, Co or Tandem? in or out or both ways? What is the NEC Expecting? CO, tie ?? problem 2, I use AAR to route special traffic, access to AAR is *88, programable under Fea acc codes.
  3. satman5152

    How to ADD gain IN the SX for through traffic

    mmcalli, I found the info on Digital Loss Plan, it is in the Little Instruction Handbook 555-025-107 under Ds1/CEPT/ISDN/PRI Reference. This shows the loss's across different types of digital and Analog interconnects. I hv not read all yet, but the projected and EXPECTed 9 db loss between Tie...
  4. satman5152

    How to ADD gain IN the SX for through traffic

    mmcalli, I saw your question in the thread before an the info on the reference to Digital loss plan. Could be my version does not support it. I increased the T-1 (ds1) gain comp to a 5, however this gain is for the T-1 bit stream, in other words, the distance from the SX to the T-1 interface to...
  5. satman5152

    How to ADD gain IN the SX for through traffic

    Teletek, Thank you, I found that one and I hv it set high on the inbound T-1 and the Out bound T-1. The children are sill unhappy! I saw a thread before about Gain plan or country gain plan. but i can't seem to locate it. Thank you again for your advise. Larry
  6. satman5152

    How to ADD gain IN the SX for through traffic

    There seems to be about 3 db loss in the SX when traffic is tie line to tie line, or tandem to tandem. Is there a way to increase the Gain in the switch? I hv a G3r V6. 1 cabinet, 5 shelfs. Thank you. Larry

Part and Inventory Search

Back
Top