Search results for query: *

What you appear to be looking for is a "brick level" backup. The individual .pst files do not exist on the exchange store. Utilities such as exmerge and backup products which support "brick level" backup can pull individual pst files from the exchange data store. If you...

Set up a connector, and set it to forward mail to the following smart host : <smtp.isp.net> In the outbound security section indicate the username and password to authenticate to this server (if required). Set all clients to use the SMTP server on the exchnage server to send mail. It will be...

Answer is it depends. If you have NIC's that support link aggregation (sometimes called Ether Channel or Ether Trunks) and a switch that supports this you can increase the bandwidth to the switch. Link aggregation drivers usually have several modes- load balancing (no increased throughput)...

Is this a multi-homed server? Your interface addres appears to be a different subnet on the same network- could be updated by RIP or other routing protocol- are these guys on the same wire or across a layer 3 switch/router? Just some things to look at...

Seen this when you try to install with the MS SQL Standard Edition- requires Enterprise Edition to do clustering

Sounds like the SCSI id's on the Adaptec card are both on the default value of 7- try chnaging the valu of one of them

This is normal- In the compaq user forum there is a description of a solution that loads a generic SCSI driver for the device and it moves from unknown to SCSI devices. This is not necessary however, as the unknown setting does not effect operation. The CR3500 is attached on SCSI bus, and is...

MSCS uses a quorum disk for cluster control- i.e. it must see the device as a local disk from all cluster members and be able to issue SCSI reservations for it. This cannot be done on a NAS device.

I did this using AMI express 300 RAID cards with Cluster Support turned on- make sure the SCSI ID's are not the same across the boxes! The RAID card you choose must have cluster support (i.e. the ability to recognize another HBA at the other end of the chain, and read config info from it). I...

Think the answer is to run setup with a -localquorum option

Can't answer your cluster of one question, but geograpically distant clusters can work up to 10k on fiber channel using the same IP subnet (i.e VLAN). If you need more than that you will probably need third party replication software, not necessarily using Mocrosoft Cluster Services- see...