Thanks for the help all,
pmesjar you were right. I had the serial cables connected in the the wrong ports. I now can get RIP and EIGRP to work.
Thanks again,
b
Thanks for the reply,
Here's what I have done:
I turned on split horizon on each interface.
I double checked to make sure that the "DCE" cable is connected to the middle router. The ports configured with the clock rate.
I also tried RIP version 2 and it did not work. I am...
Thanks for your reply,
When I do a sh int, it shows that the the serials ports are up and the line is up. But it does show that I have hdlc encapsulation turned on.
How do I turn that off?
And the dce/dte is on the correct interface if you mean that the middle router is the dce and the...
Thanks for the help,
I still have not been able to get it to work. Here's what I have done.
1) I am clocking only the middle router. The DCE router.
2) I needed to reverse one of the cables. It was plugged in backwards.
3) I turned on ip classless.
4) All interfaces are no shut.
How do...
Ok, I still can't get it to work but here is what I did:
turned off router rip and then turned it back on set it to the 3rd octet ie..
router rip
network 172.16.20.0
what I noticed is that when I did a sh run I got:
router rip
network 172.16.0.0
so its acting like it won't go to the 3rd...
I did, this is what I used:
(config)#router rip
(config-router)#network 172.16.0.0
(config-router)#^Z
I did this to all routers.
Thank you for your reply
Also I turned on debug ip rip and I get:
RIP: ignored v1 update from bad source 172.16.40.1 on Serial0.
This is on Router1, the other routers have similar messages.
b
Hello,
I am trying to set up a lab and I am running into problems. I am trying to set up three 2500 series routers back to back to back. Here's my config:
Router1:
e0 = 172.16.10.2 255.255.255.0
s0 = 172.16.20.1 255.255.255.0
Router2:
e0 = 172.16.30.1 255.255.255.0
s0 = 172.16.20.2...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.