Search results for query: *

How does aar analysis route the udp call. I can dial the tac code for the trunk-group and reach the trunk or I can put a feature code and get to the trunk, however I dont' want users to have to know if the extensions are on the call manager and if they have to dial a code or not. Essentially...

There is no where on the call manager side for me to identify the call-manager pbx with a udp code. Can you give me an example of a udp extension for example 6648 and how you would configure that in the definity to route to a a trunk-group 99.

The definity g3 pbx is connected to two other definity g3 pbx's. The PBX's are using udp and have udp codes to route calls to extensions on the other pbx's via a trunk route pattern. My question is if I remove a station from the pbx say an extension that is 4-digit 6648. If i configure a udp...

This question is for Buckweet or anyone else who can help resolve this. I am installing a Cisco Call Manager and connecting it to a Definity G3 PBX using a DS1 circuit pack connected to a 6608 T1 (PRI) gateway. Right now the trunk link is up and configured using B8ZS and ESF and ATT 5ESS...

Buckwheet - I am trying to do an installation of Call Manager 3.2 with a Definity G3 v6 PBX. I am not using Q.sig for the isdn signalling type is this a requirement. Right now I config'd a trunk between the pbx and cisco 6608 T1(PRI) using a ds1 circuit pack. I setup the switch type as...