Search results for query: *

Although these inks are cheaper, I advise you all not to do this. The density of the ink is significantly different and we see heads that have been destroyed by third-party solid ink all the time.

I know someone that made a few for our engineers, leave it with me and i'll get back to you tomorrow.

Thanks, I'll give it a try.

Hi, Does anyone have any instructions of how to setup the IP address of a Tektronix Phaser 540Plus from the front panel. I can force it to take an IP address from a postscript file, but am unable to figure out how to from the panel. I have followed the instructions for a Phaser 550, but it...

7,004.46 (0x3c04):PM_FAULT_DM_CAM_SENSOR_BAD "No transitions are observed of the drum maintenance cam sensor. The sensor may be bad or the drum maintenance cam may be jammed." Check around where the maintenance tray is lifted, make sure the tray is on and that theres nothing obvious...

When you turn on the printer from cold, it performs a cleaning routine to calibrate the printhead.. This uses a lot of ink! I don't imagine that turning it off will cause it to break more, but i'd recommend leaving it on just to save of the hideous cost of ink.

I wouldn't bother if I were you.. I change at least two or three printheads per week because of users using non-tek ink.

5,002.42: "Y-axis position failure, the drum is not where is should be, possibly because the drum position sensor electronics have failed, or because the motor drive or drive belts have failed, or because something is physically blocking the motion of the drum." Sounds like an ill...

I don't know how much use my answer is going to be, but as far as i remember, some are different.. I had a problem a while back where the black ink from one machine was melting at a different temperature than another machine, it wrote off 3 ink loaders before I realised. I can't remember though...

These things are forever breaking.. I don't know any suppliers for parts but the numbers you want are... 351-1051-00 Right guide (looking from front of machine) and 351-1053-00 Left guide They're simple to change.. Good luck mate.. Mark

Does anyone have, or know where i can get the software to use the diag port on the back of the 840/850.. I have the cable for it but cant find the software anywhere.. Thanks.

The 07.xxxxx message you mentioned is a motor stalling error, as it's only appeared once or twice it's probably a bit of crap in one of the gears.. Try whipping the sides off and see if theres anything obvious.. The 22.500 messages are media jams. 22. means media jam 5 front cover 00...

The error code means that one of the jet heaters isn't responding, usualy means it needs a new printhead. It might be worth taking the sides of and re-seating everything but if this doesn't help its a new head.