Search results for query: *

Scott, It may be easier for people to assist if you were to post the cisco config.

It is highly likely that you have something wrong with either the cabling or router interface. I would suggest checking the cabling and interfaces again, ideally replacing them.

Anybody have any thoughts on how to setup L2TP tunnels between Cisco Routers.

Seen this link, will test. Thanks

Anybody had any luck routing IPX over an IP network using GRE tunnels?

Hi, Has anybody had any experiance with TCP/IP X.25 bridging. Or know of a good book? Cheers

post the config

Totally agree Johnny. MikeS, try not to complicate matters. This is for a home user, not a corporate trying to use independent IP's using 2 different ISP's to build resilience into the network.

you wont need to tell the machines on one network about the other as long as the default route for the machines on the network is the IP of the router interface. Do not listen to the comnments about RIP "unhelpful" well said chrisac

Any broadcast will bring up your line. you need to specify an access list to allow specific traffic. I dont really see the need for you to run RIP, try using static routes.

Has anybody managed to get IPSec running on a Cisco 1720 over ADSL

clarification on what I mentioned before. indeed you will be better of using a virtual template and setting the default route to use the framed IP (fixed). This will allow you to setup floating static routes for ISDN backup, using the dialer 0 int.

I believe you might need to use a virtual-template rather than dialer interfaces. The dialer interface when used with the ATM will spoof the ATM int, so regardless of the state of the ATM int the default route will still apply because the interface still appears to be up. Dialer0 is up, line...