Allied Telesyn Convertors work OK but we have had problems following
power glitches where the Cisco interface fails to negotiate correctly and comes back up in half duplex at one end of the link although the other is in full duplex.
We find it best to set both ends of the link forced to full...
But watch you dont try to use a 2950 which only runs the standard software
image. The fixed config 2950 (with just 24 10/100 ports) wont run the
enhanced software image. Rate-limiting wont work on this one.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.