Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TouchToneTommy on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. John Tel

    System Alarm

    I had similar error on a 11.0 IP500V2 system that showed up for some time until the card actually failed. Seen on system status and email alarms. There was a small burned spot in it when it was removed. Replaced the sd and rehosted the license.
  2. John Tel

    Spectrum "POTS" lines

    If the noise is coming from Spectrum, then they must fix it. Whether they have to replace the EMTA or SBC type equipment providing the dial tone. They must provide you reliable noise free circuits. If it’s bad before the system then it will never be good on the system.
  3. John Tel

    Nortel Meridian w/ Norstar Flash CCR issue

    Are your lines set to answer the correct and setup table which is set to the correct and setup CCR Tree?
  4. John Tel

    Working IP Office 500 v1 4.2 suddenly cannot dial out on PRI. Call come in fine.

    I’m by no means an expert on monitor but looks like your call hits channel 23 for outbound sending 11 digits and then you get this below. Not sure if it’s what you are sending to the provider that they don’t like or the provider itself which is the issue. In most cases with PRI and SIP we send...
  5. John Tel

    CS1K Signaling Server partition full /dev/hda10 (Not the normal /var issue). Directory not working.

    Thanks, gbtac3. I have cleaned the /var, /home and /admin using freeDiskSpace as well as going into these directories to further clean. I've followed Avaya's PSN# PSN003828u to clean these also. I haven't given WinSCP a thought but I've used it on IPO with success. I have found that the...
  6. John Tel

    CS1K Signaling Server partition full /dev/hda10 (Not the normal /var issue). Directory not working.

    Using df will give similar output as what you have shown. Your hda11 (/dev/hda11 2.0G 1.3G 570M 70% /) looks like my hda10 where it doesn't show a folder name but mine is 100% full. I have the below information that i was able to record manually using df. I can reach out to the site to get...
  7. John Tel

    CS1K Signaling Server partition full /dev/hda10 (Not the normal /var issue). Directory not working.

    We have a customer with CS1K on 7.65 that has 2 cores located in separate buildings where both Signaling servers are on CPPM cards. They have lost directory button use on their IP phones again. This has happened in the past and a freeDiskSpace followed by reboot for both Signaling servers has...
  8. John Tel

    Nortel Option 11 call gets transferred without interaction.

    Need some guidance with a customer that has a Nortel Option 11. When a call is made out of the PRI from a analog wireless Polycom phone to a 1-800 conferencing service, the call remains active for around 50 or so minutes and then they hear what they said was a dial tone or ring back and then...

Part and Inventory Search

Back
Top