Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TouchToneTommy on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. zerowalker

    Beginner - Macros and Overlays?

    Thanks, will make sure it ssupports all those and try to make sure it's cost effective somehow!:)
  2. zerowalker

    Beginner - Macros and Overlays?

    Quite expensive application, but will check it out! I think that's what this one does, cause looking at it, it has a ton of stuff that's not used in our case. And i noticed when messing around (removing stuff as i tried to figure out where the logo was before) i enabled some other forms...
  3. zerowalker

    Sending Postscript to printer directly, how to get a reply (success, fail?)

    Hi! I have made a postscript file that i can print successfully on one printer, it messes up on others that don't have the custom page size, one atl east goes into a loop and just prints the cropped page forever for some reason. But it at least works on the intended printer, but if that rings a...
  4. zerowalker

    Beginner - Macros and Overlays?

    I strangely enough just tried that and got it working, precisely as you explain here! It was basically just luck trying to mimic the other code, but i noticed that it actually worked, thought i had tried it before with no luck, must have missed some step. So the &f#y#X is probably what has...
  5. zerowalker

    Beginner - Macros and Overlays?

    Hi, i hope this forum is the right place, it's really hard to find anywhere to ask about PCL. So to start with, i am really new to PCL, i understand some stuff from reading the instructions/commands available, but i can't really read PCL that well if it's not very basic. Now to the thing i...

Part and Inventory Search

Back
Top