Search results for query: *

Again, I appreciate the suggestions but still experiencing the same problem. Changed the CO Type to ATT and removed 25 from the Rls ID, no change in call behavior. Also tried changing route to VCE, trunk is stills set for DID. With this change I no longer get a half ring on the analog...

Even if I don't put anything in the at the RCAP prompt, then print when built, colp is there. Get the same sch0531 if I try to remove it.

COLP is the default. It won't let me Xcolp when building it. If I select another option, it puts both in.

It wouldn't allow me to remove the CLOP. Received a Swh SIDE CNEG RLS RCAP xclop SCH0531 RCAP **** OVL000 >err sch0531 > SCH0531 Unable to match input with stored mnemonics. The RCAP prompt in overlay 16 has been answered NDS when QSUr QSIG GF are not accessible or with an inappropriate...

Thanks for the suggestion, I will try that.

I do have an IDC table associated with this route, but this extension is not configured. Here is the dch programming. ADAN DCH 4 CTYP MSDL CARD 01 PORT 1 DES primcot USR PRI DCHL 1 OTBF 32 PARM RS422 DTE DRAT 64KC CLOK EXT IFC NI2 ISDN_MCNT 300 CLID OPT0...

Forgot to also mention, the inbound call will ring the phone for just a split second, partial ring and then the call drops. I an call the extension internally without issue.

Yes, the carrier is sending digits for ext. 1991. Here is the RDB and a trunk that is built. REQ: prt TYPE: rdb CUST 0 ROUT ACOD TYPE RDB CUST 00 DMOD 1 ROUT 2 DES LOCAL COT TKTP DID NPID_TBL_NUM 0 SAT NO RCLS EXT DTRK YES BRIP NO DGTP PRI ISDN YES MODE PRA IFC NI2 CBCR NO...

I'm attempting to setup a PRI with a new carrier. Outbound calls work just fine but inbound calls will connect for just a split second and then drop. Below are the d-channel messages I have captured from the call. Trunks are configured as DID and PRI is set for National. Hoping someone might...