Hello thkatana,
I understand that you want to do like: user call in and got IVR (DISA) then press ext and now you want that when user press ext number, and pbx will route call to cellphone. If this is the case, you need to have Activation Key KX-NS1xx and set Mobile Extension to Enable then...
If you don't want to involve in VoIP (SIP/H323) then I'd suggest you to use bridging. Refer to this link:
http://www.cisco.com/c/en/us/support/docs/ibm-technologies/source-route-transparent-srt-bridging/10676-37.html#ex9
BRG
Huong
Hello,
You can try SIP DECT by using TGP600 (support up to 8 handset) or IP-CS KX-NPC0154 (support up to 8 handset, handset can be TCA285/385)
BRG
HUONG
Ruan26,
Yes, for KX-NT500, need TDE100 with software ver8. After upgrade try to put Registration mode for IP Phone in PBX to Full Automatic first then see if NT Phone register or not.
BRG
HUONG
Hello,
Using rate limit command under sub-interface will do:
rate-limit
To configure committed access rate (CAR) and distributed CAR (DCAR) policies, use the rate-limit interface configuration command. To remove the rate limit from the configuration, use the no form of this command...
Hello,
With your network diagram, you can do setup to simulate T1 PRI provider by doing tunneling Q.SIG or Q.931 over SIP.
Refer to this link for more detail:
http://www.cisco.com/c/en/us/td/docs/ios/voice/sip/configuration/guide/15_0/sip_15_0_book/tunneling_qsig.html#wp1054731
BRG
HUONG
Kramla,
Try to login cisco 1841 and post your output of command show ip nat translation. You can try to add ip nat inside under Sub-interface of Fa0/1 and try again. Appreciate if you could post your 1841 configuration file.
BRG
HUONG
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.