Search results for query: *

I found the issue and everything is working. When I made changes, I was trying to run an EDD and was getting a BAD_DATA error every time I tried to save, and didn't think anything of it. So the switch was never saving my data. Apparently, the switch reset and I lost all my temporary configs...

So any idea on how to get the outbound call working? 9 + 2700 should route across SIP trunks to Session Manager. 9 = AC1 and 2700 is configured using SPN 2. Not sure where in the switch it's denying the access to those trunks based on what I've dialed. Alan Tolbert CTI/Telecom Manager CERT...

I also received this trace when making an outbound call. Hope this helps: >*ld 80 TRA000 .trcr 1 ANY TN OK . NCT400 252 0 2 17 OVF DIG_LD= 92700# 00AFB332 00AFAE95 01392FC4 01392B29 013919E2 NCT400 + 013912A3 0139F3B2 01389184 25BC124B 0138290D NCT400 + 0138252A 0137D887 0136EA54...

Thanks for the reply, but that isn't causing the issue. I have my phones and RDB's using the default TGAR/TARG of 1 and they are working just fine. Also, I think that only applies if you are trying to direct select a trunk and not use ESN NARS/BARS for call routing. The only difference I...

Thank you Allenmac for your response! Below is the RDB/DCH and TN as well as ZONES and MedSec info. Hope this helps. Please let me know if you need anything else: ROUT 10 TYPE RDB CUST 00 ROUT 10 DES SIP2SM TKTP TIE NPID_TBL_NUM 0 ESN NO RPA NO CNVT NO SAT NO RCLS EXT...

Hello. I need help trying to figure out why my outbound calls keep getting a reorder. I recently configured my 7.5 CS1K to my SM and calls work fine. This CS1K I'm trying to get working is 7.0. I can call through SM to the CS1K and calls are perfect. So I'm assuming I have a COS or CLS...