Search results for query: *

Answer point - operator console configured for day service and one extension configured for night service but when the system is on day service external calls not going through while internal calls go through. when on night service external calls go through the night service extension. Anybody...

Hi there, I have a challenge, in accessing the Mitel controller, i changed the controller IP address to match the Customer network successfully, logged in and configured the controller, then i had power cut, when power restored i am now failing to login. The controller is running normally...

Hi there, I have this task to link the above mentioned two different systems, i have linked only Mitel controllers via IP Xnet, how do i go about it?

Hi there, I am struggling to configure DHCP options on windows server, it's a first for me. I am used to using the Mitel DHCP, but for this client they want their DHCP to issue IP Addresses to IP Phones. Anyone with steps on how I should go about it please help.

Hi there, I have a faulty MXE controller-release 4.0( LAN ports blown)which I want to replace with an MXE III controller-release 7. Client has no SWA, I wanted to downgrade it to release 4.0, Is it possible for this type of downgrade?

Mitel MXE, Release 5.0

Hi, I just configured IP phones(5312) and all display Error msg assert 222, Link Maint_Resiliency, I not so sure what causes this, anybody who can assist?

Hi Everyone, I have a problem with 5550 IP Console, I installed many of these and they worked without giving any problems. Just in June this year 10 of these Ip console became faulty, checked Ip addresses assigned to them & they are ok, tried reconfiguring again but without success, this...

Hi Everyone, I am experiencing something ackward about MXE controller, there is IP address conflict, which I eliminate by deleting the second device on the network, then a different ip is said to be in conflict and this does not end. I have replaced the E2T card, but the fault persist. Anyone...

I want to load software on mitel MXE III using a PC, I am stuck on what windows features to turn on, anybody with a clue assist. Thanks

I have recently connected PRA on a Client's CX II Controller, and some outgoing calls fail with a message" IC FAIL". This did not happen while the Client was using analogue lines, i am stuck with this problem.

I have this problem that i experience when logging onto the mitel platform. This happens if i log on a platform of release 5 upwards and then log on lower versions, i will be able access the platform but can't do anything on it. i don't know how to solve this, any with the same experience help.

Good day, I have just experienced for the first time a fault concerning the E2T comms failure, in an attempt to rectify the fault I have assigned a static Ip address to E2T but the fault persist. I wondering what I can do next to rectify this.

XNET DOES NOT RECOGNIZE XNET TRUNKS, CONFIGURED EVERYTHING, BUT I WONDER WHERE I HAVE GONE WRONG

Configured all 6 PBX's,PBX Numbers and their IP addresses on network elements, ICP/PBX - assigned IP addresses, IP/XNET TRUNK Profile done, IP/XNET trunk group done, COS,ARS, but the system can not recognise xnet when i use the state xnet all command, what did i miss?

Have configured xnet for release 6, done profiling, xnet trunk group,COS,network elements, ARS ,ARS digits dialled, can not get it working