Search results for query: *

WikiTech - I do appreciate your thoughts. We already have sneak fuses for several of the off-premises runs, but I don't think for all of them, and there is not fuse protection for any of the blocks running directly to the cards. I will investigate that option further. Unfortunately, we're just...

I have free slots, but I was under the impression that you couldn't leave a slot empty to the left. Is that correct, or am I mistaken? If I can leave slot 1 empty, I can just shift everything one card to the right & do a board renumber to see if that helps. (<--- Please forgive my lack of...

joe2938 - it's a mixed bag. It's almost always different ports, some in the same building with the PBX, some in remote locations. That's why I'm struggling a little with troubleshooting this one: it's not a clear cut issue, it seems!

Yes, I do understand the need for proper grounding and protection. Some of the system is well done, some, unfortunately, is not (and I'll be working my way through it when I can). What is odd about it, however, is that this phone system has been here for more than 10 years, and the problem will...

Merlinman: we have phones all over the place. It's a ski resort, so I have digitals in three different buildings, and some analogs more than a mile from the PBX.

The cabinets are grounded well; just verified. Just put another 024 in today. Several phones dead again. Ugh.

Thanks, Dexman. Yes - I've got the PBX on a monster APC UPS, in good working condition. Will look deeper into the power supply & carrier.

Running an old Magix system here. 024-TDL is in slot 01. I've had to replace that card at least 8 times in the past year. Sometimes it's just a port or two, so I check the wiring to make sure we're not shorting/arcing somewhere. But it isn't always the same ports that go. And several times, the...