Search results for query: *

One addition. We're planning on replacing the WIC-4ESW with a WIC-1ENET interface card to take the switchport and vlans out of the config. Not sure that that will fix the problem, but it should reduce the complexity.

Sorry, I changed my public IPs to dummy IPs to minimize my potential for attack. When typing I forgot the 1 in front of the 72 so you can read that 'show cable modem' output as 172.17.2.5. As far as using the 1721 as the VPN router, it's a Federal Reserve VPN router so they control the VPN...

Ok, so just found out from my ISP that my cisco is still throwing IP addresses out. I'm at a loss. Here's their proof. CMTS:7A#show cable modem 001a.dea8.be3c hosts Intf Prim Prim Prim Connect Timing RxPwr Ip Address Mac Address Cable DS US Sid State Offset dBmV...

Thanks for your input tphethai. I think I figured it out at the end of the week last week. I ended up setting my access group in/out both on the Fa0 instead of on vlan 15. Did some testing with ICMP traffic and got the rest sorted out after that. Also, since I was natting my internal ip of...

I'm with jpm121 on this one. Something in the translation between the two routers got messed up. Good posibility it's in the routing tables or your WAN IP changed.

Does your external IP match up with your mx record? I guess I would check that first.

Ok, here's my setup. Internet ---- Cable Modem ------ Cisco 1721 ----- Cisco VPN Router ------ Computer 172.17.2.1 72.17.2.5 (ext) 10.10.10.2 (pub IP) 10.10.10.1 (int) I'm working on the Cisco 1721. I'm trying to set up some pretty restrictive...

Hey all, I'm trying to do some PBR to run traffic to 2 specific subnets through a WAN optimizer. The remote end is an inline optimizer so all outbound traffic is automatically optimized. The local end is out-of-band so I need to use PBR to route all other subnet traffic to it. 192.168.0.0/24...