Search results for query: *

Does any have or can point me to the procedures for performing a sysload on a CS1000e?

Exactly, with the plug in the smartjack the carrier loop thru with no issues.

When I put a loopback towards the CS1000e the red alarm goes out and I receive the following messages; DTA022 228 DTA005 228 DTA007 228 DCH055 DCH: 3 RLS NO RESPONSE TIME: 14:01:15 21/10/2013

Also, When I unplug the cable from the smartjack and plug it right back in, the dch will establish and when I try to make a call I get a PRI222 error. Shortly thereafter the DCH will release. See Below DTA022 228 DTA023 228 DCH054 DCH: 3 EST REMOTE TIME: 13:52:00 21/10/2013 PRI222 DCH: 3...

I do have a loopback plug and I connected it to the port on the smartjack that the pbx is connected to. The carrier send the loopback with no issues.

Sorry for my haste in typing. It should read, I have done loop backs from the smartjack back to my switch...

I have an ISDN PRI that's down, The carrier says the problem is on my end. We have a CS1000E, there are two other ISDN PRI circuits installed in the same module that are not having any issues; We are using TMDI cards for all our T-1's. I have down loop backs from the smartjack back my switch and...

Yes I do.

IT'S A PRI. IT'S SET UP AS A ESS4

It's a PRI connection and the following are the DCH messeges; DCH 6 OMSG ALERT REF 0000807D CH 208 23 DCH 6 IMSG STATUS REF 0000807D CH 208 23 CAUSE: MSG NOT COMPATIBLE WITH STATE STAT: CALL INIT ST DCH 6 OMSG DISC REF 0000807D CH 208 23 CAUSE: MSG NOT COMPATIBLE WITH STATE DCH 6 IMSG...

They are 7 digits in the CS1K.

we have a 7 digit dial plan so calling from the hipath will be 7 digits.

Thanks for responding. Where do I check trunk to trunk in the CS1K?

I have a CS1k (main switch) tied to a Hipath 4000. When dialing from the CS1K to the Hipath 4000 there is no issue but when trying to dial the Hipath 4000 I can't dial to an extension on the CS1K but I'm able dial from the Hipath to the local and long distance T1's that are connected to the...

I need help configuring a CS1000e with a BRI connection to a Tandberg 6000 via an ADtran 512. I have three lines configured for ISDN BRI but, I'm unable to connect to any far end system. Any help would be greatly appreciated.