Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. hotrod7380

    CCC Reports

    DID calls are forwarded unconditional to a Hunt Group Rotary call is answered no problem. The problem is when the customer runs DID summary reports it shows no calls being answered for those DID's. Not sure where to look anymore any help would be great, Thanks.
  2. hotrod7380

    Valcom VIP-801

    Has anyone install a VIP-801 and have gotten it to work? Main site is a CS1000E rls 5.5 with an SRG at the far end, have RDB, Trunk,RLB and CDP built with DSC. In the NRS have endpoint built as a static ip address with routing entry of the dsc. On the Valcom have endpoint named the same, same...
  3. hotrod7380

    CPMG Config

    Ok I understand that the IP addresses are the same for the Call Server and Linux Server, but what about the MGC part? Is this a Virtual IP address, I would think will conflict with the other on start up, I was reading where they could only go into the cabinet or chassis and not the MG1010, Thanks.
  4. hotrod7380

    Hunting works but fdn does not

    Sfa is in the cls, the hunt dn and the fdn are different
  5. hotrod7380

    Hunting works but fdn does not

    I have three analog sets, CS1000E 7.5, the three sets hunt in linear so ,1 2 3 just fine. The problem is when 1st hunts to the 2nd it will not follow the fdn (VM). The cls has fna hta on all three sets with the first two set are programed to fdn to vm and the last set with both hnt and fdn going...

Part and Inventory Search

Back
Top