Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
-
FUJITSU 9600 - Trunk to Trunk Connection
I found the problem, but I don't know how to close this post.- mjs222
- Post #2
- Forum: Fujitsu: PBX systems
-
Problems using the VACDN
Ok, I got it to work. But I did some test calls this morning. Everything looks good but caller ID from the outside. I can get the 4 digits both way accross the PRI. But when I call from any outside number, my cell, from a transferred call or from the my office phone, dialing 9+XXX-XXX I get...- mjs222
- Post #4
- Forum: Fujitsu: PBX systems
-
FUJITSU 9600 - Trunk to Trunk Connection
Need to do a trunk to trunk connection from a FIPN to PRI CISCO and from Super Trunk T1 to the same PRI CISCO.- mjs222
- Thread
- Replies: 1
- Forum: Fujitsu: PBX systems
-
Problems using the VACDN
That is 601 and it's in every COS 0-63- mjs222
- Post #3
- Forum: Fujitsu: PBX systems
-
Problems using the VACDN
I am now trying to program in the access over the new PRI to CISCO. I have programed in the Trunk Groups Dch 202 and Bch 203, access code *30. All that look good, but then I go to use VACDN for X5730 or X8299 (to DSTNO 100 = *30) the display says DENIED or if I call over the FIPN it says Invalid...- mjs222
- Thread
- Replies: 3
- Forum: Fujitsu: PBX systems
-
MML
Yes, the MAT is set up for 7,E,1 and baud eate is 9600. It is also set to echo-off and capture-none- mjs222
- Post #9
- Forum: Fujitsu: PBX systems
-
