Search results for query: *

Pots = Plain Old Telephony System. In this case cisco has a VoIP-BRI card inside which is connected to Alcatel PBX. So when the call come from voIP "world" into cisco, it has to know which way to go, and then cisco look for matching dial peer which in this case is "dial-peer voice 2 pots" and...

hmmm... I am using ip address of the system for panasonic, which is 10.50.244.69. That what you saw above (10.50.244.70) is what Cisco write in his tests...(show call active voice brief) Below is settings for cisco dial-peers which match in unsuccesseful call dial-peer voice 2 pots trunkgroup...

Yes... the systems are not talking to each othther (rx 0/0...) but why?. Ip address 10.50.244.70 is address of Panasonic VoIP-DSP. I tried different codex and when they are mismatched nothing passed through, but when the same codec is in Panasonic and Cisco then only signalisation passed (the...

I am using V-ipgw16 on Panasonic (in Gateway configuration, not Gatekeeper). I think that is well configured because I already use this Panasonic for H323 trunking with another Panasonic PBX on another location.

I perform tests on cisco and here is examples of "show call active voice brief" tests. First is test from succesfull call from other destination and second is test from unsuccesfull call from Paanasonic.. First (succesfull call) 120A : 117 272612740ms.1 +14780 pid:1 Answer 6294 active dur...

yes this is VPN... I also have other destinations coming to the cisco and they call is establishig well. But from destionation of Panasonic only signalisation came through... no voice...

I am trying to make H323 trunk between Panasonic TDE100 and Cisco router 2801. I also have PBX Alcatel oxo attached to cisco BRI card. The idea is to make call from panasonic subscriber (over h323 voip trunk) across cisco router to Alcatel subscriber. I configured all three systems but there is...