We are running our voicemail using exchange. There is an option to "Play on Phone". This is hit or miss. When you click the option you get a dialog box to input your extension. Afte you enter your extension and hit the dial button the phone rings but sometimes you get audio and sometimes you...
Tried it and still nothing. I don't get any sort of SIP or RTP signaling from the MITEL system when the extension is dialed. I think I should see something on the port.
I have two extensions X2910 and X6000 the both use Route 3.
Route 3 is a Routing medium SIP Trunk to SIP Peer Profile Exchange.
SIP Peer Profile Exchange goes to the Network Element Exchange. (I should not have used the same label for both the SIP Peer Profile and Network Element.)
The...
In my ARS Digits dialed I have.
Digits Dialed - 2910
# of Digits to Follow - 0
Termination Type - Route
Termination Number - 3
Route 3 is my Sip Exchange Route.
I have to believe that it is my routing out of the Mitel. The wire shark displays nothing. Where is the link between the...
quinalt what do you mean when you wrote. "Since we couldn't forward directly to the sip trunk, we created a speed dial (in my case 6100) that pointed to the Exchange sip trunk."
I have 6000 setup as our ARS digits Dialed and we are dialing it from my phone.
We still have not gotten this to work. I setup wirshark to mirror the port on the 3300 and I also setup a Linksys 2102 sip device. I get sip and rtp traffic when I call the 2102 device but I get nothing when I dial exchange. I am going to look at your post and repeat your steps.
Mark
thanks boombox56 I will run this by the exchange person. We were looking for a place to start looking and you gave it to us.
LoopyLou. I have the newer document and it shows the Mitel configuration very nicely but it does not go into the exchange configuration in the same detail. It does...
That is pretty much the same document for older versions. We still cant figure it out. If we test from exchange we can dial a phone and answer and the exchange is able to gather digits entered on the phone. If we call exchange from the mitel phone we get dead air. I think it is a signaling...
I am going to build a small website about this and post the document there. Hopefully we can share info about this and leave the site up in order to help others. I will post back to this when it is done. I hope to have it by the end of the day today.
The document is SIP CoE 10-4940-00117 I am also not sure if I can post it as an attachment. If there is an administrator out there that can answer this maybe we can help each other out during this process. I am new to both Mitel and Exchange 2010 and I am still not sure which end my problem...
I have the doc for setting up UM on exhcange 2010 and when I test from exchange it is all good but when I try to dial exchange I get dead air? If I set my SIP Peer Status to Auto Detect/Normal I get a SIP Link State of "OUT OF SERVICE" If I set it to Always Active I get dead air but my Sip...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.