Search results for query: *

I figured out the new card is a ESIB8-U20 and the old card is a ESIB8-U10. The new -U20 card has a strap on it to select whether the card is a -U10 or -U20. By default the strap was in the -U20 position. Since the original card was a -U10, I changed the setting and the phones came right up. I...

I installed the new esib-8 card in slot 2. Existing esib8 in slot 1 and sli 4 in slot 3. It didn't recognize so I programmed ports 13-20 in 7-1 and programmed Exts 112-119 in 4-10. I still have nothing at the 66 block. Any ideas? I do have active led flash.

Thanks Belevedere! I appreciate the reply. I will probably install tomorrow and will update on the result.

I need to add an ESIB-8 to a Electra Elite IPK cabinet. It currently has one esib-8, a cot-4 and a sli-4. my question is do I need to power down the cabinet to add the card? and once the card is installed do I have to go to 7-1 to add it in programming? once that is done i figure i can go to 6-4...

Thanks for hanging with me GHTROUT. i appreciate all of your ideas and support!

here is a little more info...i did stat serv in ld 96 on all systems(3 option 11's and 1 option 61). if the pri is a tie line from option 11 to 61 and option 61 to 11, stat serv was enbl on both ends. if the pri was going to telco i.e. DID circuits, stat serv was dsbl. i logged into the option...

Here is what i have. This is the stat in ld 60 on the option 11 switch. these tie lines go to an option 61 switch. There is another pri for outside lines in this switch, its Service Restore is yes. I also did a lcnt with results listed below, all zeros. the prt ddb for trsh 05 in ld 73 is also...

Thanks, GHTROUT. i have to work out of town today but will try when i return and post the results.

yes, when i stat the loops yellow alarm processing is yes. i also reset the counters.

Thanks GHTROUT for your reply. I checked the settings in ld 73 and found they were set in threshold 5 to BIPC-2 and LFAC-3. i was able to change them both to 0 but when i checked ld 60, it was still showing service restore: no. i also noticed there is a threshold 0 and a threshold 5 in ld 73...

First of all thanks to all for the help you provide! I have 3 option 11's connected to an option 61 via PRI tie lines. On one of the systems, the service restore in LD60 is set to no which I assume means if the PRI goes down the channels will have to be manually enabled. is there a way to...