Search results for query: *

It is not a PRI. Since I was not having trunks provisioned as loop start, I did not set reliable disconnect. worth a try. I believe I set trunks as TIE-PBX in order to have DIDs work.

I already checked that with Vendor.

I am installing Magix to replace Partner ACS control unit in order to provide customer remote call forwarding with delay. The T1 in Partner is providing DID #'s. I programmed T1 with TIE trunks to make DID's work. Inbound and outbound calls work. I have programmed phone for TRK to Trk transfer...

Trying to set up a calling group on Magix R4. Squared key mode with all phones having ringing lines appearing. They want to use queuing as backup. Set up call group with all phones on group ring, lines routed to CG. All lines continue to ring on phones continuously. With only one phone logged...

Not sure what you are looking for as far as Magix config. It is set for 5ess. The default protocol for 5ess is AT&T custom. It will not work with NI 1 nor NI 2. It does dial plan routing, so the extensions are matching at 4 digits. All 23 B-channels are programmed to B-channel group 1. Frame...

The Magix is set for 5ess. The provider is using an Adtran IAD. His settings are interface pri 1, isdn switch type 5ess, isdn name-delivery setup, calling-party name-facility-timeout 0, connect t1 0/2 tdm-group 1, digits transferred 4, role network b-channel-restarts enable, no shutdown. voice...

Cannot get a PRI to work consistently with a PRI programmed out of a IAD device. Provider says they are taking errors beyond their IAD. They have it programmed as a 5 ess with AT&T custom protocol. It is an Adtran IAD, but I have had problem with Cisco device also in past and had to go to T1...