Search results for query: *

Thanks.

Ok, I got some assistance from them indirectly, and now we can use the lines to go out as well. If I configure the lines as: E&M Dial Mode: Pulse Signaling: Immediate I can make outgoing calls, but cannot receive incoming ones. If I change the signaling to Wink Start, then I can...

OK Curlycord, It isn't the Nortel tech I need, but as DBrewsky suggests, I need to verify again with the telco. They have not been cooperative thus far, but I will give them another shot. Thanks.

no busy, just a long dial tone, then the phone gives me 'not in service'

I have actually done this before, but with no joy. I gave a phone access and then dialed 8. I got a dial tone, but dialing a number didn't stop the dial tone, and then if I recall correctly I got a busy tone after that.

Should be 0000.

I have one of the lnes configured as E&M now, with Line Type as PoolB. Under routing, I have: Route Use Pool DN Type 001 B Public(Unknown) Destination Code 8 for Route 001 (SDT 8) I want to put the lines in a pool (B) and use 8 as the code to call out...

Point taken. The carrier has said that they have allowed for outbound also. Trunk type: DID Line Type: DN:* Dial Mode: Tone Loss Package: Medium CO Signaling: Link Start Line Tuning Digit: 1 Auto Privacy: Yes Restrictions...

I have a BCM50 with DTM module. Our service provider has supplied us with a T1-DID which works great for incoming calls. They also say that the T1 can be used for outbound calls as well. At present, we are using analog lines for outbound calls. I have tried to configure the lines on the T1 for...