Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
-
two MAC addresses on one NIC
I have an IBM server with a Broadcom BCM5708C NIC. The switch that it is plugged into is detecting two MAC addresses from the server. I am not doing NIC teaming and do not know where the second MAC is coming from. Any Ideas? Thanks- 2836Net
- Thread
- Replies: 1
- Forum: Extreme Networks networking solutions
-
-
DHCP - VLAN tagging
I would like to tag vlans rather than use the cisco "switchport access" command on every port. If there is a way to say that any computer starting with the name "XYZ" can be in one VLAN, and any computer starting with "ABC" is in another VLAN. This would prevent the need to constantly be...- 2836Net
- Post #3
- Forum: DNS/BIND/DHCP/WINS Issues
-
DHCP - VLAN tagging
Is there a way to vlan tag with DHCP so I don't have to put vlan id's on all switch ports? I am using cisco switches and feel it is going to be an administraive nightmare to control each port individually as apposed to tagging by computer name. Thanks- 2836Net
- Thread
- Replies: 4
- Forum: DNS/BIND/DHCP/WINS Issues
-
IPSEC problems
I see your point, there is a sub interface, and I have the crypto map on the physical interface. Let me take a look at my config and make sure that isn't a typo. Thanks all! -
IPSEC problems
192.168.2.0 is the subnet on the remote router, I hadn't included that interface because the traffic on the WAN interface is what I want to encrypt. In the ACL I had interesting traffic, but changed it to allow any traffic just to see if it would work. The actual acl that I want on the remote... -
IPSEC problems
I am having a problem setting up an ipsec tunnel on a new remote site. When I do a "show crypto isakmp sa" it says everything is active, and when I do a "show crypto ipsec sa" it says it is connected but nothing is being encrypted. Here are the configs on both sides: remote router: crypto...
