Search results for query: *

thanks for all your inputs.Here is the setup LAN(192.168.1.0)-->FW(not a PIX)-->WAN(209.x.x.1)----> 208.x.x.1(WAN)<--PIX<-- LAN (192.168.1.0) If NAT is not possible on the PIX ,maybe I should try NAT on the other end

Iota, I have 2 sites with the same internal subnets and was hoping could overcome this by NATing one subnet when going through the VPN. I was able to accomplish this by replacing one pix with a a 2600 router running IOS 12.1 I was hoping that the PIX could provide me the same NAT features...

Iota, Could you elaborate I want to NAT my 192.168.1.0/24 to 172.16.2.0/24 when destined ONLY 192.168.2.0 through the VPN all encrypted traffic through the VPN for 192.168.2.0 should be as source of 172.16.2.0( not 192.168.1.0) thanks

I have a VPN established to another IPSEC device without NAT partial PIX config is ver 6.1 nat (inside) 0 access-list 101 access-list 101 permit ip 192.168.1.0255.255.255.0 192.168.2.0 255.255.255.0 where 192.168.1.0 is the subnet on the inside of the PIX how do i NAT a the 192.168.1.0...

I have a Pix 515 running ver 5.2 How i allow ICMP to all the interfaces

I have a setup IPSEC/IKE VPN to a peer gateway I am trying to setup NAT for the network behind the PIX. My internal network is 192.168.20.x and I would like to NAT this to 172.16.2.x going into the tunnel 192.168.20.x ---PIX --tunnel ----- Peer gateway---- 10.10.10.x I am trying to NAT...

I upgraded from ver 4.4 to 5.2 using the monitor mode can i reinstall ver 5.2 again from the monitor mode or do i have to ue another method to reload ver 5.2 1)when i go into monitor mode and setup IP address,tftp server ,file name etc it does not copy the file. I am unable to ping in...

I am trying to setup a PIX 515 with ver 5.2(6). How i setup ICMP access to the firewall interfaces I am unable to ping the outside interface