Search results for query: *

We received two new (used) switches today and after upgrading to the newest firmware, we set up the exact config that was posted to this forum (the second one using vlan2, not the 555). This setup worked exactly as expected with no problem. Before calling cisco we did a _debug arp_ command and...

I have just spent 90 minutes on the phone with Cisco support. The tech used web-ex to have direct control of the cisco console login and tested thoroughly. The Cisco tech concluded that _both_ of these switches have a hardware failure / failing and should be replaced! Thanks for all the input.

whykap: The config you are commenting on was the original config that has since been blown away. We are not using vlan555 (or the config you are referring to) at this time. Thanks

VinceWhirlwind: Here is the output from the show vlan command: lanex1#show vlan VLAN Name Status Ports ---- -------------------------------- --------- ------------------------------- 1 default active Fa0/2, Fa0/3, Fa0/4, Fa0/5...

Unclerico: Here is the output of sh int fa0/1 switchport on both switches: lanex1#sh int fa0/1 switchport Name: Fa0/1 Switchport: Enabled Administrative Mode: trunk Operational Mode: trunk Administrative Trunking Encapsulation: dot1q Operational Trunking Encapsulation: dot1q Negotiation...

The 172.16.1.1 is not assigned to any physical interface on this network yes, however, the ping test was directed from 172.16.180.1 to 172.16.180.2 and vice-versa. In my 30+ switch network, I have specified no default gateway and they are sharing, pingable and etc. with no issue. Thanks

I do not see the problem can you please explain?

Alright -- I must be doing something completely wrong with this Cisco config. After 30+ configs of new and used ciscos could it be that I am forgetting the basics? My situation is slightly changed from the earlier description. I have two new (used) cisco WS-2950G-24-EI switches running the...

VLAN555 is the management Vlan with the IP scheme of 172.16.0.0 so no default gateway is needed. I am just wondering if there is an issue with these switches as I have two of them that do the same thing we have set up at least 20 others with no issues at all but for whatever reason these two...

Shamrock#show conf Using 1810 out of 32768 bytes ! version 12.1 no service pad service timestamps debug uptime service timestamps log uptime no service password-encryption ! hostname Shamrock ! enable secret 5 $1$zCjw$AeH/S/oWKId5h1adDJfA00 enable password ********** ! wrr-queue bandwidth 10 20...

We have recently purchased a used Cisco 2950G and using the network assistant we can see other switches plugged into it via trunk ports but am unable to see the new one from any of the other switches. Can ping from the new to the old but not from the old to the new one. We have wiped the config...