Search results for query: *

Tested with a workstation today, and everything looks to be working good. I am still connected using a crossover cable, I will switch over to the real T1 on wed. I went w/ unnumbered mainly because I read that with a single point to point it is easier. Thanks, Joe...

Minue, Thanks for sticking with me on this, I really appreciate it. I acquired this 1711 already in place. I agree that the current config is confusing & over complicated, but it is in place and working. I believe that whoever was configuring this router previously would just add new changes...

Minue, Yes that is correct, I have to go through SAC2620 then the Core to reach the internet. Currently I can ping any device or router from either subnet. What I cant do is hit anything on the internet from the remote office. I believe it is an ACL issue, but am having little luck in...

Okay, So the two subnets are once again routing between each other properly. I have access to the home office network from the remote office network and vice versa. Does it take some time for the 2620's to build a route map or something? This didn't work until the routers had been on and...

Minue, I have included an ascii schematic, does this help out? ------------- | Internet | ------------- | ---------------- | Core 1711 | | 192.168.30.1 | ---------------- | | ----------------------- -------------- -------------- | Home Office LAN |--| SAC2620...

okay, I was able to get the Point to Point working using a T1 X-over cable on my test network... However once I took them to the production network, it stopped working! I configured a static route on the "Core" router, but still no joy. I suspect that it has to to with the ACL's, but need...

Hey Guys I need to setup a point to point T1 using two 2620XM's each with a WIC-1DSU-T1, between two offices. I am a Cisco beginner & can't seem to find any clear instruction online, any help would be appreciated. The current "core" router is a 1711 which I have the running-config, ACL's & ip...