Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations IamaSherpa on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. RichardG3XWH

    Phaser 8200 part identification

    The tray is fine, in fact I can get it to feed from the manual feeder OK. The Mylar strips are fine also, the paper gets past these and into the upper feed unit where it moves in about 1cm and stops.
  2. RichardG3XWH

    Phaser 8200 part identification

    Have released the solenoid but the paper still stops after being taken about 1cm into the upper feed unit. The flag board is new and I have checked the long flag and it seems fine.
  3. RichardG3XWH

    Phaser 8200 part identification

    Thanks for the reply. Looks as if this is nothing to do with the feed problem then so back to square one (unless this is sensed in some way to inhibit feed?)
  4. RichardG3XWH

    Phaser 8200 part identification

    The photo attached is of a part that fell into the space below the paper tray of an 8200. Have looked through the service manual but cannot find this (flag1 of the Fig 8-8 is the closest but it is not that) The printer now feeds paper to the Upper feeed assembly and stops. Have replaced the...

Part and Inventory Search

Back
Top