Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
-
MAP3735NP size once in server
I have a raid 5 array that I need to replace a drive in. I've tried several 73GB drives but their configured size once in the machine is 70007mb. The maxtor drive that needs replaced is 70024. so my question is, is anyone else running this drive or any other 73gb drive and could they check to... -
expanding array on 4200 in windows 2000
Can this be done? It gives me data loss can occur error when trying to do it from windows. Can it be done in a dos or bios mode or booting from the cd or is it more related to windows not recognizing the new array size? It's strange that NT supports it but windows 2000 doesn't. -
non-transparent call from mail server IP address
I have seen this when we were setting up smtp redirecting. This usually means that someone it trying to send mail to your mailserver which is inside your network or some similar service and you don't have the redirecting rules setup. once they are setup you should not get this error unless you...- gnewtzie
- Post #2
- Forum: Security, hacker detection & forensics
-
Suggestions for hardware?
I'm looking to setup a 3 site vpn over t1 internet connections Site A: Full T1 Need 15 vpn connections into this site and web access for all persons inside the network Site b: DSL 764 with need for 5 vpn connection and internet access for all persons inside network Site c: T1 with...- gnewtzie
- Thread
- Replies: 0
- Forum: Security, hacker detection & forensics
-
Cisco 2611 with Multilink problem (Callref)
VECLFRout#sho int bri 0/0:2 BRI0/0:2 is down, line protocol is down Hardware is PQUICC BRI with U interface MTU 1500 bytes, BW 64 Kbit, DLY 20000 usec, rely 255/255, load 1/255 Encapsulation PPP, loopback not set, keepalive set (10 sec) DTR is pulsed for 1 seconds on reset LCP Closed... -
Cisco 2611 with Multilink problem (Callref)
Building configuration... Current configuration: ! version 12.0 service timestamps debug uptime service timestamps log uptime service password-encryption ! hostname VECLFRout ! enable secret 5 $. ! username g username g no ip subnet-zero no ip domain-lookup isdn switch-type basic-ni ! ! ... -
Cisco 2611 with Multilink problem (Callref)
I'm setting up a 2611 with isdn u type wic card and am unable to bring the second channel up. I've tested just calling into the second channel and I get the same error when dialing just that number. The debug isdn q931 shows the call coming in but when the router sends the connect back it...
