Thanks for the advice Michael52x. It turns out the swing plate that I was sold was actually for a LJ 4200 and it must be a fraction too small for the gear to actuate the fuser assembly on the 4250. So after all is said and done I ended up tearing it all down again and just using the gray...
Hi folks,
I just went through the ugly task of replacing the entire swing plate assembly on one of my 4250's. The issue I get now is that once it gets back together and tries to print it jams continuously. I've traced it back to the fact that the fuser gears are not engaging and spinning the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.