Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. dubey42001

    IPO 7 - Changed Module from analogue to digital DSM 8A

    ip500 v2 7.0 (125004) thanks
  2. dubey42001

    IPO 7 - Changed Module from analogue to digital DSM 8A

    Yes 7.0
  3. dubey42001

    IPO 7 - Changed Module from analogue to digital DSM 8A

    hi thanks for your reply, I have done re boots swapped cards over when system was off, still the same
  4. dubey42001

    IPO 7 - Changed Module from analogue to digital DSM 8A

    Can anyone advise on this issue, I have removed Analogue Module from slot four and replaced it with a Digital 8 Port Module. Once rebooted this module doesnt come up. One red LED is on permanently on port one? Have done the obvious, swapping cards over, all ok Anyone got any ideas Cheers Mark
  5. dubey42001

    testing auto attendant with no lines

    Hi does anyone know what short code to use to ring the AA while I test IP Office v7 with no isdn30 lines?
  6. dubey42001

    bcm 3.7 to 4.0 upgrade

    Thanks for all these pointers but none have worked. Any more out there before i get tangled up with Nortel. Thank you
  7. dubey42001

    bcm 3.7 to 4.0 upgrade

    Hi, I am unable to upgrade my bcm3.7, as soon as i run the first disk and enter my upgrade keycode i get an error message "Problem with keycode, return value is 8". I have checked my system id and it is correct. would be gratefull for some advice. Thanks Mark

Part and Inventory Search

Back
Top