Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. rbsims

    NAT Confusion

    I just wanted to thank everyone for their input. I don't understand why Cisco would porvide a range without a prefix. In any event, if the question indicates that the ISP provided the range, it has to have a VLSM mask (unless you purchase a class c). But thanks again, you guys are great
  2. rbsims

    NAT Confusion

    I recenty took the CCNA exam and came across the following issue You are given an ip range of 172.16.1.50 – 172.16.1.59 from an ISP. Can you determine the prefix by adding up the number of IP addresses, and finding what VLSM block size they fit into (172.16.1.50/28) for purposes of creating an...
  3. rbsims

    Is DCE/DTE configurable???

    Guys Let me see if I understand this.... If i connect the dce end of the cable to a serial interface, that will make that interface dce? The state of the interface is a function of the cable type plugged into it? I thought I tried various combinations with several interfaces and routers. But...
  4. rbsims

    Is DCE/DTE configurable???

    I go into serial0/0 and input clock rate 64000 I get the message Can't configure clock rate on a dte interface. I tried switching the cable to the DCE side, and get the same results. thanks
  5. rbsims

    Is DCE/DTE configurable???

    I bought several 2500 series routers off ebay to start a lab. Some serial interfaces are DTE, and some are DCE. Is this configurable or hard coded??? I searched high and low, and couldn't find the answer. Thanks guys
  6. rbsims

    Lab Routers Not starting eigrp routing process

    That was it!! Thanks for your help. I guess I assumed that the serial links would be auto detected, wrong. Thanks again
  7. rbsims

    Lab Routers Not starting eigrp routing process

    R2#sh run Building configuration... Current configuration : 846 bytes ! version 12.1 no service single-slot-reload-enable service timestamps debug uptime service timestamps log uptime no service password-encryption ! hostname R2 ! enable secret 5 $1$lKb1$e.NjGKnvV3pdcXza48Yqn0 enable password...
  8. rbsims

    Lab Routers Not starting eigrp routing process

    I will send the config along tonight. The lab is at home. If you have a suggested config I have no problem starting from scratch. The only static route I have configured is the default route 0.0.0.0 0.0.0.0 s0 Thanks so much for your help
  9. rbsims

    Lab Routers Not starting eigrp routing process

    I have three 2500 series routers. I configure them for "router eigrp 100". I do a sh ip proto and all say they are running eigrp 100 and advertising the configured networks. I do a sh ip route and no eigrp routes are in the table. I do a de bug eigrp nei, and get no output. If I do a sh cdp...
  10. rbsims

    Traffic Shaping In PIX

    Hey Guys I'm new to PIX and trying to determine it's capabilities. I have geographic redundancy to a single ISP. I want to route specific subnets (VLANs) through one edge router and the balance through the other. Can this traffic shaping be done via the PIX? If so, any suggestions how to...

Part and Inventory Search

Back
Top