l never believe in patch work. The cable is not that expensive to get a new long one. Secondly you want to eliminate any doubts if you ever have problems. You may suspect the cable and other things at that time. Use the coupler as a temp fix and get a new long cable.
Good luck
Avaya recommends all their equipment to be set to 100/full/ duplex to match your LAN. i have a similar condition. Changed both speeds and everything works ok now.
Kaystel
Has anyone heard or performed phone firmware upgrade on a CM and the system went down? or my question is can a IP phones firmware upgrade render the system to be down?
I think you guys are right about the complexity of the configuring additional phones. l believe it will be done on the G450. I have to engage Avaya for help.
thanks for the response. however actually what l meant was how the phone were programmed to work during fail situation. When i went to the site with a vendor tech, we invoked the sho run command on the gateway was able to see the these phones. l need to add more how do i accomplish this.
Thanks
Hello all,
one of my sites have a g450 with a T1 going in and configured for failover instead of s8300. currently only three phones are configured to work in case WAN goes out. How and where do l configure the remaining phones to work when WAN goes down.
i appreciate you all
kaystel
a vendor installed a DCP board on g700. this was due to calls fading out during calls. there is a RED alarm on the card how do we get rid of this alarm? is upgrading the firmware help. Any suggestions?
Thanks
Kaystel
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.