Thanks AvayaTier3,
That looks like a sat session command (not shell) ...
term ossi locks up the screen
command: newterm
respnse: Terminal Type (513, 715, 4410, 4425, VT220, NTT, W2KTT, SUNT): [513]
-----
input ossi and enter
output: t
.... (on far right of screen)
screen now frozen
The LX is not in question here. OKC-AI is not in question here.
The question is what form in the PBX would have the Audix name - what form other than the node-name audix form ?
It is the audix1 that I am attempting to remove from the PBX.
I had a new LX Intuity installed and connected. At the time I left the old Intuity on the system to run the new and old side by side a few weeks for the users. The time has come to remove the old Intuity.
Audix Names IP Address
audix1 172.18 .2 .33
When attempting to remove...
Save the announcement via Val manager to your PC
Admin the announcement on the other board – in the Avaya system
If you have a different name for the announcement you can change that once the wav file is on your pc
Upload the announcement to the new VAL – via val manager
I know this isn’t...
How do I check or test the short holdover mini ups and if it comes down to replacing these batteries, how is it done and can be it be done without replacing the whole PDU?
I have the following alarm – on an MCC
01 POWER y MINOR y 08/19/21:41 00/00/00:00
Red light on the TN775 in the maintenance slot next to the IPSI
test environment 01 results in
01 POWER 5 FAIL 8
No...
Since you said you are using DIDs directly from your carrier perhaps you can use the number conversion table for the trunk group. Convert the number to a different number that you can use as a VDN.
Using the number you convert to create a VDN that points to a vector. In the vector have a step...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.