Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. CBRRyda

    Client to Router VPN driving me nuts

    JPF, I'm having a somewhat similar problem with my Cisco 1811W and VPN IPSEC using the Cisco VPN Client. Can you explain in more detail your statement, "Using a route map to prevent traffic from my internal lan to be natted between the VPN lan did the trick." I'd greatly appreciate it. Thank...
  2. CBRRyda

    Cisco 1811 VLAN and Routing Questions

    vbahuse, Did you mean the SDM (Security Device Manager) for the 1811 Router config? I think the CNA is for configuring the switches. I too, am trying to get VPN Clients to connect to devices on VLANs defined and connected to my Cisco 2960 switches; which are trunked to the 1811 of course. Does...
  3. CBRRyda

    Cisco 1811 VLAN and Routing Questions

    vbahue, Thanks for inquiring. I have all of my VLAN and Routing issues taken care of. I am however, still working on my VPN IPSEC setup, have not quite got that working correctly yet. I will also be looking at any posts to the thread. Regards, CBRRyda
  4. CBRRyda

    DSL on Cisco 1811W

    Thanks brianinms and burt; brianinms, when I try to add the second (ip nat inside) to the config, I get the following error: "%Dynamic mapping in use, cannot change" burt, what commands should I use to encrypt the telnet, enable, and console passwords? Thanks All.
  5. CBRRyda

    DSL on Cisco 1811W

    Ok All, sanitized version of config below: ------------------------ cisco1811w#sh run Building configuration... Current configuration : 7003 bytes ! version 12.4 service timestamps debug datetime msec service timestamps log datetime msec service password-encryption ! hostname cisco1811w ...
  6. CBRRyda

    DSL on Cisco 1811W

    Thanks Burt, I'll have to try the unplug T1 access after hours and see what happens then. I'll let you know.
  7. CBRRyda

    DSL on Cisco 1811W

    One more question, Can you add a second Cisco config line: ip nat inside soure list 10 interface FastEthernet1 overload Without the second line interfering with the existing equivalent line but on FE0 for NAT\PAT? Thanks Again. CBR
  8. CBRRyda

    DSL on Cisco 1811W

    I ordered and installed DSL at my office location, as a backup to our existing T1 WAN connection. I have setup, configured, and tested the DSL connection, it works. Our T1 access is connected to my router's FE0 port, the DSL is connected to the FE1 port, as a DSL Ethernet handoff. I have...
  9. CBRRyda

    Cisco 1811: VPN using PPTP with MPPE

    Hello All, Newbie here again. Does anyone have a working sample config or example, of a Cisco 1811 Router using VPN over PPTP with MPPe. Thank you in advance for any assistance.
  10. CBRRyda

    Cisco 1811 VLAN and Routing Questions

    All, I now have the Cisco 1811W. I am trying to do the following: 1. Create 3 VLAN's for: LAN1, LAN2, and Wireless 2. Route between the VLAN's and to Internet 3. Configure some of the ports on the Router for specific VLAN's; FE4-5 VLAN11, FE6-9 VLAN12 4. FE2-3 are Trunk Ports to connect...
  11. CBRRyda

    Cisco 1811 VLAN and Routing Questions

    All, I'm a newbie and in charge of upgrading our existing VPN and routing solution. I'm looking at the 1811 w\wireless and had some questions: 1. If you separate FE2-5 ports to VLan1 (IP x.x.1.1), and FE6-9 to VLan2 (IP x.x.2.1) for local inside subnets; does the router support DHCP Relay...

Part and Inventory Search

Back
Top