Search results for query: *

I've recently obtained a cisco pix 525 firewall, it powers up but stops booting whaen it states its the secondary firewall in a failover system. It won't let me boot past that point. Is there a way to restore/reset the unit so that it can be configured as the primary firewall ?? thanks note...

minue, I am starting off slow, as my funds are limited. When I get to the point of setting up a home lab designed for the CCNA exam will I need a switch ?? The 2514s just seemed like a good choice. They're inexpensive and I believe you can set a 2514 for NAT, that way I could actually...

thanks guys wiimike that was the prob, i forgot to add the subnet as well and the old router config was using a different class subnet so I couldn't "see" it from the router. all set now, i've got the 2500 IOS up and running on one router, ive backed up the "dumbed down" IGS image on the router...

good tips ... i'll give those try and let you guys know how it turns out.

OK... so I finally got around to getting a tranciever for one of my 2501s. On both routers I have cisco IGS software (I think its for frame relay stuff)on both routers (one has a corupt flash image). I have a copy of the 2500 IOS on my PC. I have already tried to upgrade the IOS using...

thanks...I feel better now,... but they really need to fix their message boards. :)

I myself am getting started with some used cisco stuff. currently I have a couple 2501s that for now are just sittin' on my desk... at some point i'd like to migrate the routers and any other equipment i've procured to a skeletek rack. the small version can be found for about $100, but they're...

I needed to order up a couple of transceivers for my 2501's.. so I found the site ciscokits.com, I'm wary about ordering things on ebay so this looked like a good place to get parts. I'm a bit concerned though as browsing their site shows the forums over run with spam messages, there are a few...

So I've tried everything listed above and I still have had no luck... but I have found that my router is loading the bootloader image instead of the IOS. also I cannot (no matter what I do) get the router into ROMmon mode.... It just boots to Router(boot)> I have spent hours on the CISCO...

The problem is... I don't have an ethernet connection on the AUI port yet is the 172.16.1.2 internal, or will I need an external connection to the net ?? sorry .. I'm new to this and just trying to get the router going for learning until I can grasp CISCO software a little better.. Thanks...

OK short and sweet... I'm new at this so bear with me I went through CISCOs process for resetting a 2501 I recieved but did not have the password for ...but along the way I must have done somthing wrong... although I was able to change all the passwords... NOW every time I boot the router it...