Search results for query: *

I already use Netflow Analyzer, but that's no good for real time statistics. I need something like the linux utility 'iftop', which looks like this: http://mcdouglas.dyndns.org/2009-02-12_1530.swf The router has NBAR installed, but knowing what the traffic is not that important, I need to know...

Hi, How can I monitor who is using the internet in a given time? I know I can install a netflow monitor, but that will only generate me graphs for daily, monthly, hourly usage. I need something like the linux iftop utility: http://www.ex-parrot.com/~pdw/iftop/iftop_normal.png Sometimes...

Solved the problem. nat (inside) 0 access-list NO_NAT Silly me, forgot that the inside interface is not used, but the intranet one. I guess this is what you get, if you don't clean up your config after removing the DMZ subnet. Thanks for the suggestions anyway.

Just for testing, I allowed ANY traffic in ACL for both interfaces. Still no luck. Can't even ping the PIX's internal IP address.

If I enter what you wrote: pix(config)# access-list NO_NAT extended permit ip 192.168.61.0 255.255.0.0 192.168.81.0 255.255.255.0 ERROR: IP address,mask <192.168.61.0,255.255.0.0> doesn't pair I guess you wanted to type 24 bit mask, so i tried that too. Still could not ping the inside network...

Well I think the command nat (inside) 0 access-list NO_NAT does exactly that. VPN client's are not NATed.

Yes, there is, actually the PIX is the default gw. But I can't even access the PIX itself from the VPN client.

Hello, Sorry, by remote network i meant the HQ end, where the PIX is. I think split-tunneling is enabled in the group policy. You got me with the route-back thing. I'm not sure about that. Here is the route table. pix# show route Codes: C - connected, S - static, I - IGRP, R - RIP, M -...

Hi, I'm having problem setting up remote access VPN with a PIX515E. I can establish a connection with the Cisco VPN client, but after that, i can't ping or access anything on the remote network. I marked with bold the commands i used to set up the VPN config. My config: pix# show run : Saved...