Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
-
HiPath4000 ISDN PRI status "Ready/CP"
I am trying to bring up a new circuit in a new trunk group and cannot make outbound calls. The carrier says everything looks good on their end. I verified the circuit protocol is NI2. I believe the circuit needs to show status "Ready" in Dis-SDSU but all the BChannels show "READY/CP". Is there...- nspitzer
- Thread
- Replies: 3
- Forum: Siemens: Hicom
-
Remove RDS session
Thanks. I ended up rebooting Assistant and that cleared it.- nspitzer
- Post #3
- Forum: Siemens: Hicom
-
Remove RDS session
Hello all, I recently took over maintenance of a HiPath 4000 Version 6 and have learned my way through AMO and ComWin but ran into a major issue holding up progress. Right now my issue is I need to do some troubleshooting on a PRI and I was tracing using the RDS (RealTime Diagnostic System) tool...- nspitzer
- Thread
- Replies: 2
- Forum: Siemens: Hicom
