Search results for query: *

Hey Rodjor, The 2811 has the below configuration, where Gb 1/0/2 is the internal interface that links the 2811 to the switching module and the loopback interface is the IP by which the 2811 is managed. I admit that the design is not exactly tidy, but I couldn't think of a better way to do this...

Howdy Folks, I have a 2811 fitted with an NME-16ES-1G ether switch module and I would like to manage it using LMS 2.6. I require the module be managed by a specific IP address, namely the IP address associated with VLAN 1. The problem is that whenever the switch module responds to polls from...

Hi Guys, No i didn't quite manage to get this working in the end. I've read that it is possible but I believe that Cisco does not support it - their recommended solution for this situation is L2TPv3 (for which you will require 12.3(2)T and above, depending on the Cisco model). Here's an...

Hi Well I'm using a 2651 and a 2811 for proof of concept so yes, using existing hardware. I haven't had much experience with frame relay - will this allow me to encapsulate the bridged traffic to enable traversing a public network? In the meantime I have made progress with my attempt at...

Hi All, I have a requirement to remote bridge between two private sites over an IP WAN link. I have the restrictions below: 1. The hub site and remote site must operate on the same subnet. 2. Hub and remote are private networks seperated by multiple hop public infrastructure. 3. Remote site...