Search results for query: *

thread690-1567747 Ok, after reading through the previous post I just figured I'd make a quick cable for the G350/G700 console cable. Basically I simply cut the RJ-45 end off of a Cisco cable and by already knowing the PINOUT of the Avaya cable. I wanted to make it easier on techs out in the...

Has anybody ever heard of a 512MB DAL2 board being recognized as a DAL1 Board ? I'm trying to upgrade a CM 3.1.2 to 5.2.1, I swapped out the DAL board and I cannot get the upgrade to initialize because it still thinks there's a DAL1 board in there. The new DAL2 board shows its a DAL2 on the...

http://support.avaya.com/japple/css/japple?PAGE=avaya.css.ProductDetail&temp.groupID=107529&temp.selectedFamily=152705&temp.selectedProduct=136527 try that !!!

You may want to check your reliable disconnect on your system as well, chech under Lines and Trunks in System Program and make sure disconnect is set to Yes Charles

Rdusel, You, need to know that you cant program just any extension to this dss console. you can only program extensions x00 to x99 in a 3 digit dial plan or xx00 to xx99 but only 50 @ a time unless you have 2 dss consoles. The 2nd set of buttons @ the bottom of the the console, top row from...

If your phone defalts to an intercom button and you dialed 891 or 892 without dialing a 9 1st and you don't have an ASA/DXD card, THAT would cause the message to appear. in order to get rid of the message hit Feature 0 0 from ext 10 or 11 then hit the left intercom button twice then hit # 728...

I have 2 Nodes in a DCS Environment Intuity is sitting on Node 1 when I call a station on Node 2 it never rings into coverage, UDP is setup Correctly, and so is the Intuity Hunt Group in Node 2 because I can dial the HG Ext and get into the V-Mail Login prompt. The two switches are linked via...