Search results for query: *

howdy. i have a general question concerning call setup and call handling. i am in search of how a call actually works through the 3 control protocols. im pretty sure h.323 handles call setup AND all voice traffic as well. as opposed to sip where setup may be handled by one and the actual...

thanks for the help!

Thanks for the info. I see control is COS3 and media is COS5. I was working on a 3550 that has 4 queues, with one of them for priority. Having only 1 queue for priority, I think I can only match one COS label to it. This is a problem if I saturate a layer2 trunk upstream (since only media is...

Is there a best practice for mapping dscp or cos to voip control and voip media traffic? I am looking for a doc that says voice control in most cases should receive dscp X and cos of X. The same for voip control. I understand that it could vary on each network but there must be a general...

i have the fxo port configured with a DN of a voip phone for inbound calls(future i plan to have autoattendant) and i have a route plan for the fxo port, 9.@

i found some doc and have it somewhat configured but am haing issues. there is another post regarding fxo and fast busy. thanks for your help

this is a ccm install.

when i configure a route pattern to exit my fxo card, it works. but when i attempt to dial digits following the connection i get a "phone has been off the cradle too long". so i have a route pattern for the number 9. i pick up a phone, enter 9, then i get dialtone. after i attemt to dial...

i would start with the cisco callmanager administration guide. google it. also i hear cisco press has some good into.

ideally i would like something for all cisco devices, but mainly for a cat 6500. thanks

is there a command or mib oid to get a switch chassis serial number and card serial numbers? any ideas or scripts or anything would be great. thanks

i have callmanager and a gateway with a fxo card. what do i all need to do to get it to work? i cant seem to find any doc on configuring it, or at least anything i understand. i would like it so my voip phones can call out on it, or have people call in on the pots line. thanks

EDIT ABOVE POST- the pots phones are configured with ccm. they are hanging off of a 3725 which is using ccm as well.

Can i conference with pots phones off of a 3725? is there any doc? thanks

I got it working. I had a prefix DN entered which broke things. thanks everyone

i would log in and see what proc is killing it. then i would find out if it is an ios issue. if these things are ok then post the config.

silly me,, this works pc(db9 female-- straight cat5--db9female--gender bender)776

hello, i need to build a console cable for a cisco 776. the router has a female db9 connector on it which confuses me. i have a cisco build female db9 to a rj45 adapter, which i plan to plug into a db9 adapter i have. but i need help in customizing the pinout of the male db9 connector. pc...

when i enter "ccm-manager" these are the only options i see: config-download switchover-to-backup i dont see any option for an ip address. the gatway knows about the ccm from "mgcp call-agent 192.168.55.2" right? thanks and i look forward to more ideas

it didnt work. any other ideas? thanks