Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
-
Possible Routing Problem
I have two routers Cisco 877 ADSL connected to the Internet that is working perfectly. It is using a public static IP on the outside interface and a private 192.168.1.2 on VLAN1 on the inside, the router has 4 FastEthernet ports. NAT is setup correctly because I can get to the Internet from any... -
Cisco 877 ADSL problem
Thanks, This helped me a lot. I really appreciate it. -
Cisco 877 ADSL problem
I have a brand new Cisco 877 ADSL router and I cannot figure out how to configure the router with the IP address to the ISPs default gateway. I have the interface dialer0 set to my public static ip as shown in Cisco's documentation. Do I need to set the ATM0 interface with an IP? The... -
WIC-1DSU-T1 Back to Back
I ran those commands and here is the result; Router 1 WIC Slot 0: FT1 BT8360 Hardware revision 1.3 Board revision B0 Serial number 23498537 Part number 800-03279-04 Test history 0x0 RMA number 00-00-00 Connector type Wan Module EEPROM format version 2... -
WIC-1DSU-T1 Back to Back
I have tried for two days to get my two 2621 routers connected back to back each with WIC-1DSU-T1 cards. I have made two T1 crossover cables in case I had the first one wrong. I have read everything I could find on it at cisco.com and various other websites. I have tried every combination of... -
WIC-2T Serial Interfaces
I have 3 brand new WIC-2T cards installed in 3 2621s. The company sold me the following serial cables; CAB-SS-530MT and CAB-SS-232FC. When I try to bring up the serial interfaces the interface stays up but the protocol goes down after a couple of minutes. Do I have the wrong cables? I intially...
