How do I enable the directory function (press 9 in the main greeting)remotely? When you press 9, it says you have dialed too few digits and repeats the greeting.
Any help would be appreciated!
Does anyone have experience setting up a BCM50 thru a Cisco 2900 switch? I am trying to set this up on our bench so I can test the IP phones. I have all of the keycodes loaded, the digital and analog phones are working.
I am configuring the BCM using the Manager and the 2900 using the web GUI...
Yes, it is a MICS...NVRAM is release 1. The problem reoccurs when unplugged. I am going to install a FastRad so I can back up the programming and install a new software cartridge. Thanks for all the input!
I have a good one...on a CICS/7.0 with PRI, when the system is shutdown (due to power outtage) the systems clears the destination codes, everything else comes up fine.
I reprogrammed the destination codes...9 any, route 1, absorb=01 and everything worked, customer can make calls (which was the...
That is very interesting...both were set for NI-2 and I couldn't make outgoing calls, so I was told to change it to 5ESS. This solved the outgoing call issue, but seems to have caused another with the LD/TF. I will try changing it to the other types and see what happens. Thanks!
Thanks...but if I set asborb to "all" it will send the 9, and and if I send "none" it won't send anything.
As I have been researching the other posts, do I need to build a seperate route for LD/TF? Then program each 91xxx?
This is a fractional T1 using 6 lines for voice...it is straight...
Just installed a PRI on a MICS w 7.0...everything works except dialing "1" for LD or toll free. To make a call you press ITCM,9,then dial the number. When I dial LD or TF I get the message "you must dial 1 and the area code for this number."
I have the routing set up, Route 1 to PRI-A...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.