Search results for query: *

Sorry, I meant to say that it was just a C: drive and I cloned it into one of the partitions (C: drive) on another Hard Disk. I made a D: drive on the new Hard Disk also

Ok, thanks for the note mscallisto. I've done this and will try removing the USB Stick and see what happens

One other thing that the Acronis post has made me think of: This hard drive that I have was created (C: and D: Drive) by doing a copy using the Acronis software. Is this a common occurance??

I AM using Acronis software. I have the trial versions (Which have expired) installed of Acronis True Image Home and Acronis Disk Director Suite. I'll uninstall them now and see if that fixes the problem. Thanks!!!

When I left click on the 'Safely Remove Hardware' icon on my taskbar and select safely remove hardware, after a few seconds I am getting the following error: |-RUNDLL-----------------------------------------| |An Exception occurred while trying to | |run "shell32.dll,Control_RunDLL...

Ken,Thanks for the response. I was able to get into the Octel via dial in yesterday. I set up Hyperterminal for TTY. I got a few unusual characters at the end of a line waiting for a response, but other than that, the menu came up without any problems. I'll go in and check menu 6-3 and see what...

I'm pretty new to the Octel system. How do you set it up to where you can administer the Octel switch via a dial up connection?? Can you use Hyperterminal?? What settings do you have to set Hyperterminal to (8-N-1 or ?-?-?, 57600 or ???. etc)??

I have a Benchmark DLTtape DLT1/VS80 tape drive that I would like to enable Compression on. How would I do this?? Also, I would like to check to see what version of Firmware is on this drive and update it if it needs to be. I've looked at the manaul on how to do this, but I can't understand how...

I've seen the following in other posts and would like to know Detailed instructions on how to do this: Verify your TTY is set up to match the same baud rate as your modem and you should be good to go. How do you do this on the Meridian 11c switch?? What card are you connecting to because you...

I need to know what ALL commands to execute at the terminal hooked up to an Meridian 11c to print out all of the settings so I will know the following: baud rate to set the modem to 8/N/1 or 7/E/1 Flow Control On or Off Error Control On or Off etc, etc, etc I'm new to the Meridian switch, so...