Hey there,
I have a cisco 1720, I set it up, have the running-config copied to startup-config.
I have saved the startup-config to the nvram, but whenever there is a power cycle, I lose the configuration. Not sure what is wrong with it, but it appears to just be failing out entirely.
I am...
Hey folks, you have been tonnes of help, I have my cisco box up and running with a single outbound connection.
So my current config works but I am trying to set port-specific traffic to run out a different gateway.
On ETH1 I have a second DSL which is dedicated to my colo, and I want to route...
Eth0 is a 6mb down 1.5 up dsl
eth1 is a 1.5/256 dsl
With no-route to eth0 that would place all my outbound traffic to eth1 yes?
I am trying to route a block of addresses out eth1 specifically 64.94.136.x
with the remainder of the routed traffic headed out the faster eth0 connection.
In any...
Ok, I purchased a used 1720, and popped the t1 wic out of it, upgraded IOS, and installed a pair of ethernet wics.
The goal is to set my system to route outbound traffic for VOIP out of ethernet1 and all other traffic out of ethernet 2.
I however can not even get the unit to route traffic.
my...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.