Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. winger15

    VOIP over Cat 5e Shielded Cable?

    Hello, Thanks for all your replys, we are installaing shelded cable due to the high RF activity within the building,ex: internal cell phone transmitters, Broadcast transmitters, etc. Today I used an Avaya One-X IP phone at another site and it did have a "Hollow" Echo side tone to the...
  2. winger15

    VOIP over Cat 5e Shielded Cable?

    Hello All, Any possible problems with installing and operating IP Phones over Cat 5e Shielded Cable? It has been mentioned to me that the phones may sound like they are in a tunnel or sound "Tinny", The users will be coming from a traditional PBX system over to the VOIP phones will they notice a...
  3. winger15

    T1 Cable Extension Distance?

    Thanks to all for your replys.
  4. winger15

    T1 Cable Extension Distance?

    Hello All, I have to extend a T1 Circuit from the demarc room, out to an IDF wiring closet, approx. 400 feet away. I am thinking of using T1 Cable, 22 AWG, 2 pair shielded for the cable run, and terminating it in the IDF on a RJ48X jACK. any comments would be appreciated. Thanks
  5. winger15

    Shielded Cat 5e Patch Cord RJ 45 Plugs?

    Thanks to all of you, your response is very appreciated.
  6. winger15

    Shielded Cat 5e Patch Cord RJ 45 Plugs?

    Hello All, Is the "Shielded" Cat 5e Patch Cable Plug the same foot print or size as the Cat 5e UTP Plug, I have been told the are have a larger footprint and may not plug into the base of an Avaya VOIP Phone set? Thanks for any info.
  7. winger15

    T1 CKT. TESTING

    Hello All: First time on Board!! With ?. After your local telcom co. installs a T1 CKT. and I extend it from the Demarc to a point where it is needed, but the end equipment has not been installed yet is there any way to test the ckt. to verify it is good ?. Thanks

Part and Inventory Search

Back
Top