Finally figured this one out. The ISP was looking for individual clocking on each T1. So the clocking has to be configured for independent clocking.
controller t1 0/0/0
clock source line independent
channel-group 1 timeslots 1-24
I had to do this on each controller and now everything is ok...
Doing that made my other controllers start getting errors.
T1 0/0/0 is up.
Applique type is Channelized T1
Cablelength is long gain36 0db
No alarms detected.
alarm-trigger is not set
Soaking time: 3, Clearance time: 10
AIS State:Clear LOS State:Clear LOF State:Clear
Version...
Serial0/0/1:1 is up, line protocol is up
Hardware is GT96K Serial
MTU 1500 bytes, BW 1536 Kbit, DLY 20000 usec,
reliability 255/255, txload 112/255, rxload 128/255
Encapsulation PPP, LCP Open, multilink Open
Link is a member of Multilink bundle Multilink1, loopback not set...
I am having som Slip Secs errors and Errored Secs show up on one of my controllers and was wondering how to stop them. The ISP says nothing is wrong on their end and they see no errors in the mux. Here is the out come from sh controllers T1 0/0/1
T1 0/0/1 is up.
Applique type is Channelized...
I pinged from 100.2 to 1.233 and got destination unreachable
I pinged from 1.233 to 100.2 and got the same thing
Then I tried pinging from 1.234 to 100.3 and got destination unreachable.
then again from 100.3 to 1.234 and got the same thing.
When I applied the ACL inbound the above pings...
I created a test VLAN100 and used the existing VLAN1 and created 2 different access-lists.
1st ACL I created was
access-list 101 permit ip host 192.168.100.2 host 192.168.1.233
access-list 101 permit ip host 192.168.100.3 host 192.168.1.234
access-list 101 deny ip 192.168.100.0 0.0.0.255...
Sorry about that VLAN 9 is our voice database. And pretty much everything needs to be able to talk to this vlan. Basically I don't wan't any other traffic allowed other than the traffic specified above. You your saying in order for this to happen the acl's should be applied outbound instead of...
I have just purchased a new 3560 for my company. This is brand new out of the box. I have written up some access-lists and I was just wondering if they would work correctly when put into production. Here is what I have so far. I basically want to know if I have the traffic allowed in one VLAN do...
I have a tunnel to a remote site set up in my pix515 firewall and up until sunday morning it was working fine. I didn't make any changes on my side and I spoke with the IT guy on the other side and everything looks fine. I have a policy nat on my 192.168.11.0/25 network that translates it to...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.